Er. Mobi Mathew

Designation: Assistant Professor

Education:  B. Tech., M. Tech., PG Dip., MBA, PG Dip.

Professional Experience
Teaching:2years
Research: 6.5 years

Industry: 1 year

Specialization
UG : Bachelor of Technology (B. Tech) – Electrical & Electronics Engineering

PG : Master of Technology (M. Tech) – Energy Management, Auditing & Lighting

Master of Business Administration (MBA) – Power Management

Post Graduate Diploma (PG Dip.) – Renewable Energy

Post Graduate Diploma (PG Dip.) – Environmental Law

Ph. D: Pursuing

Publications

I have published 40 articles in reputed journals and conferences. As per Google Scholar, I have achieved a citation count of 664 with an h-index of 11 and an i10-index of 13. I have achieved a cumulative impact factor of 26.086 (till 29 February 2024). A list of the articles is given below:

International Journals

  • H. Baby, J. Jayakumar, M. Mathew, M.G. Hussein, N.M. Kumar, “Analysis of reactive power loadability and management of flexible alternating current transmission system devices in a distribution grid using whale optimization algorithm”, Renewable Power Generation, IET, 2022, pp 1 – 15.
  • M. Mathew, S. Hossain, S. Saha, S. Mondal, and M. E. Haque, “Sizing Approaches for Solar Photovoltaic Based Microgrids: A Comprehensive Review”, Energy Systems Integration, IET, 2021, pp 1 – 27.
  • N.M. Kumar, U. Subramaniam, M. Mathew, A. Ajitha, D. Almakhles, “Exergy analysis of thin-film solar PV module in-ground mount, floating, and submerged installation methods”, Case Studies in Thermal Engineering, Elsevier, 2020, vol. 21, pp 1 – 11.
  • P. Gangwar, N. M. Kumar, A. K. Singh, A. Jayakumar, and M. Mathew, “Solar photovoltaic tree and its end-of-life management using thermal and chemical treatments for material recovery”, Case Studies in Thermal Engineering, Elsevier, 2019, vol. 14, pp 1 – 8.
  • N. M. Kumar, R.P. Gupta, M. Mathew, A. Kumar, and N. Singh “Performance, energy loss, and degradation prediction of roof-integrated crystalline solar photovoltaic system installed in Northern India”, Case Studies in Thermal Engineering, Elsevier, 2019, vol. 13, pp 1 – 9.
  • N. M. Kumar and M. Mathew, “Comparative life-cycle cost and GHG emission analysis of five different water heating systems for residential buildings in Australia”, Beni-Suef University Journal of Basic and Applied Sciences, Elsevier, 2018, vol. 7, no. 4, pp 748 – 751.
  • M. Mathew, N. M. Kumar, and R. P.  Kororth, “Outdoor Measurement of Mono and Poly c-Si Modules and Array Characteristics under Varying Load in Hot – Humid Tropical Climate”, Materials Today: Proceedings, Elsevier, 2018, vol. 5, no. 2, part 1, pp 3456 – 3464.
  • N. M. Kumar, M. R. Kumar, P. R. Rejoice, and M. Mathew, “Performance Analysis of 100 kWp Grid Connected Si-poly Photovoltaic System using PVsyst Simulation Tool”, Energy Procedia, Elsevier, 2017, vol. 117, pp 180 – 189.
  • M. Mathew, N. M. Kumar, and M. P. Subeekrishna, “Design and Computational Analysis of Daylight Integrated Energy Efficient Lighting Scheme”, International Journal of Earth Sciences and Engineering, Vol. 10, No. 1 Special, 2017, pp 12 – 17.

International Conferences

  • N. M. Kumar, H. Basha, and M. Mathew, “Evaluating the Life Cycle Cost of LPG Instantaneous, Storage, and Boosted Solar Water Heating Systems in Australia”, 7th World Conference on Applied Sciences, Engineering, and Management, 2018, pp 1 – 3.
  • K.P. Vasudev, M. Mathew, A. Anand, and J. Hossain “Performance Analysis of a 48 kWp Grid connected Rooftop Photovoltaic System”, Fourth International Conference for Convergence in Technology, IEEE, 2018, pp 1 – 6.
  • A. Sharma, M. Mathew, I. Mitra, and N. Anwer “Approaches Leading to Different Definitions of Smart Grid: A Review”, International Conference on Power Energy, Environment and Intelligent Control, IEEE, 2018, pp 603 – 609.
  • H. Kaushik, M. Mathew, and J. Hossain “Comparative Analysis of Green House Gas Emission from Different Vehicular Fuels”, International Conference on Power Energy, Environment and Intelligent Control, IEEE, 2018, pp 704 – 708.
  • A. Negi and M. Mathew, “Study on Sustainable Transportation Fuels Based on Green House Gas Emission Potential”, International Conference on Power Energy, Environment and Intelligent Control, IEEE, 2018, pp 421– 425.
  • R. Maity, M. Mathew, and J. Hossain, “Increase in Power Production of Rooftop Solar Photovoltaic System using Tracking”, International Conference on Power Energy, Environment and Intelligent Control, IEEE, 2018, pp 416 – 420.
  • N. Kanetkar, L.K. Sreepathi, and M. Mathew, “Evacuated Tube Solar Cooker with Ethylene Glycol as Sensible Heat Storage Medium”, International Conference on Power Energy, Environment and Intelligent Control, IEEE, 2018, pp 331 – 337.
  • M. O. Dioha, A. Kumar, M. Mathew, and J. Hossain, “Comparative Performance Analysis of Different Silicon-based Photovoltaic Technologies in Nigeria”, International Conference on Power Energy, Environment and Intelligent Control, IEEE, 2018, pp 581 – 587.
  • M. O. Dioha, N. V. Emodi, M. Mathew, and E. C. Dioha, “Techno-Economic Feasibility of Domestic Solar Water Heating System in Nigeria”, International Conference on Power Energy, Environment and Intelligent Control, IEEE, 2018, pp 54 – 60.
  • S. Subramaniyan, M. Mathew, and J. Hossain, “Renewable Energy Capacity Value Estimation using Peak Period Method in Rajasthan”, International Conference for Convergence in Technology, IEEE, 2018, pp 1 – 6.
  • S. Subramaniyan, M. Mathew, J. Hossain, and A. Kumar “Capacity Value Estimation of Renewable Energy in Maharashtra using Peak Period Method”, International Conference for Convergence in Technology, IEEE, 2018, pp 1 – 6.
  • S. Gayas, M. A. Wagay, and M. Mathew “Feasibility Assessment of Small Wind Turbines Based on Wind Energy Density”, International Conference for Convergence in Technology, IEEE, 2018, pp 1 – 5.
  • M. Mathew and J. Hossain, “Analysis of a Grid Connected Solar Photovoltaic System with Different PV Technologies”, International Conference on Circuits and Systems, IEEE, 2017, pp 264 – 269.
  • M. Mathew, S. G. Kini, and E. P. M. Shafeeque, “Energy Analysis and Load Reduction Strategies for a Low-Rise Building in Composite Climate of India”, International Conference on Circuits and Systems, IEEE, 2017, pp 245 – 250.
  • S. N. Kumar, M. Mathew, N. Karthikeyan, and J. Hossain, “Development of Permanent Magnet Axial Flux Generator for Small Wind Turbines”, International Conference on Circuits and Systems, IEEE, 2017, pp 43 – 48.
  • M. Mathew and S. G. Kini, “Daylight Analysis and Enhancing Strategies for a Low-Rise Office Building in Composite Climate of India”, International Conference on Circuits and Systems, IEEE, 2017, pp 21 – 25.
  • V. Muralikrishnan, S. Adarsh, and M. Mathew, “Error Minimization of an Angle Sensor using LabVIEW Based Calibration”, International Conference on Intelligent Computing, Instrumentation and Control Technologies, IEEE, 2017, pp 1308 – 1311.
  • Y. K. Sharma, M. Mathew, and K. Yanamandram, “Enhancement of the Biogas System Application Using Solar Photovoltaic and IoT Based Automation”, International Conference on Intelligent Computing, Instrumentation and Control Technologies, IEEE, 2017, pp 851 – 855.
  • M. Mathew, Y. K. Sharma, and M. A. Magry, “Design and Analysis of Solar Photovoltaic Based Coal Mine Reclamation in India”, International Conference on Intelligent Computing, Instrumentation and Control Technologies, IEEE, 2017, pp 372 – 375.
  • A. M. Johnson, K. R. Shailesh, and M. Mathew, “Energy Efficient Lighting Design for a Food Processing Industry Located at Composite Climate of India”, International Conference on Circuits Power and Computing Technologies, IEEE, 2017, pp 1 – 5.
  • B. Paul, V. Kamath, and M. Mathew, “Economic Analysis of an Energy Efficient LED Based Lighting Scheme for a Pharmaceutical Industry”, International Conference on Innovations in Power and Advanced Computing Technologies, IEEE, 2017, pp 1 – 7.
  • P. S. Junaidh, A. Vijay, and M. Mathew, “Power Enhancement of Solar Photovoltaic Module using Micro-climatic Strategies in Warm-Humid Tropical Climate”, International Conference on Innovations in Power and Advanced Computing Technologies, IEEE, 2017, pp 1 – 6.
  • B. Paul, V. Kamath, and M. Mathew, “Lighting Audit and Energy Efficient LED Based Lighting Scheme for a Pharmaceutical Industry”, International Conference on Innovations in Power and Advanced Computing Technologies, IEEE, 2017, pp 1 – 5.
  • M. Mathew, V. P. F. Ali, M. K. Yasir, and K. Shibiyas, “Occupant Comfort Analysis of an Educational Building Located in Warm-Humid Tropical Climate”, International Conference on Innovations in Power and Advanced Computing Technologies, IEEE, 2017, pp 1 – 5.
  • A. Vijay, M. Mathew, and P.K. Rohith, “Development of an Economical Digital Control Method for a Continuously Running Conveyor Belt”, International Conference on Inventive Systems and Control, IEEE, 2017, pp 711 – 715.
  • B. Paul, M. Mathew, and S. G. Patil, “Modelling and Thermal Analysis of Honey Comb Heat Sink for LEDs in Street Lighting Applications”, International Conference on Inventive Systems and Control, IEEE, 2017, pp 706 – 710.
  • M. Mathew and S. G. Kini, “Daylight Analysis of a Typical Low-Rise Office Building for Different Climate Zones of India“, International Conference on Energy Efficiency Technologies for Sustainability, IEEE, 2016, pp 549 – 553.
  • D. Jose, M. Mathew, and A. Krishnan, “Weather Dependency of Electricity Demand: A Case Study in Warm Humid Tropical Climate“, International Conference of Electrical Energy Systems, IEEE, 2016, pp 102 – 105.
  • M. Mathew, F. F. Nellissery, A. Anand, A. Varghese, and S. K. Panoli, “Development of a Small-Scale Power Generation System using Rooftop Ventilator“, Student Conference on Electrical, Electronics and Computer Science, IEEE, 2016, pp 1 – 5.
  • M. Mathew and Siddhartha, “Analysis of Outdoor Thermal Comfort in Warm and Humid Tropical Climate“, International Conference on Emerging Trends in Engineering, Technology, and Science, IEEE, 2016, pp 1 – 6.
  • M. Mathew, S. G. Kini, and A. Gupta, “Seasonal Daylight Analysis of a Mid-Rise Office Building Located in Composite Climate”, 8th National Conference on Advanced Energy Conversion Technologies, AECT, 2016, pp 1 – 4.

Memberships

  1. IEEE
  2. IEI

Research Interest

  1. Microgrid – Size Optimization, Design, Energy Management
  2. Floating PV systems – Potential estimation, size optimization, sustainability evaluation
  3. Energy Trilemma and Energy Justice, Circular Economy in Power and Energy sector

Patents

  1. NIL

Reviewer

I am a reviewer for numerous high-impact journals of Elsevier, IEEE, Springer, and MDPI publishers. I have completed 123 reviews for the journals of Elsevier (till 29 February 2024). The journals for which I have served as the reviewer are listed below:

ElsevierAin Shams Engineering JournalEnergy Nexus
 Energy and Built EnvironmentEnergy Reports
 Expert Systems with ApplicationsHeliyon
 Frontiers of Architectural ResearchResults in Engineering
 Renewable and Sustainable Energy TransitionResults in Optics
 Energy Strategy ReviewsResults in Physics
 Sustainable Energy Technologies and Assessments 
 Engineering Applications of Artificial Intelligence 
 e-Prime – Advances in Electrical Engineering, Electronics, and Energy
 Book Proposal – Intelligent Control in Smart Energy Systems
SpringerOptimization LettersEnergy Systems
MDPISustainabilityDesign
 Energies 
IEEEAccess 

Contact Details

Mobile: +91 9447364016

Email: mobi.mathew@saintgits.org